![]() The Most Common Reason a Combination Safe Won’t Openįirst, be sure you are dialing the combination correctly. See When You Need to Drill the Safe below for details. Locksmith will need to drill out the relocker to open the safe. If the safe fell or was hit, a relocker may have fired to lock the safe down. You will need a locksmith to drill the safe. See Know the Difference between Loose Handle and Clutched Handle below.Įverything appears to operate, handle turns, but bolts don’t retract. Handle will freely spin even before a code is entered. Typically, a hex screw secures the handle to the spindle. Push on the bottom of the door with your foot while pulling and turning the handle. Pressure on the bolts can prevent the bolts from retracting. If this works, hire a safe service / locksmith to service the dial before closing the safe. Left-right? Right-left? Did the dial stop?ĭials wear out and the numbers for the combination drift. What to Do When the Combination to Your Safe Does Not WorkĪre You Dialing the Safe Combination Correctly? What to Do When Your Safe Combination is Not Working ![]() If these tips don’t get you in, it’ll be time to call a locksmith that does safe openings. In the following table we show the problem, the cause, and what to try to get into a safe when the combination is not working. In all but the most serious cases, you will be able to open the safe on your own. Call a locksmith for serious safe failures (such as broken mechanical linkage in the door or a re-locker that has been thrown). If that does not open safe open, test for wear on the dial (a.k.a “drift”). When a safe won’t open with the combination first try relieving pressure on the bolt work of the safe and check for a loose screw in the handle. If you’ve LOST the combination to your safe, checkout our video on YouTube “ How to Get Into a Safe When You Don’t Have the Combination.” That video will guide you on your options, and what you will need to do in order to get in. You are certain it’s the correct combination but for some reason the combination will not open the safe. Your safe combination has stopped working. If your safe fails to open, then you'll have to take your rod and repeat the process.Dial Safe Won’t Open Using the Combination Enter your new combination on your safe's exterior keypad to ensure it was set correctly. If ten seconds pass without a sound, then assume your code has been set. If you don't hear one right away, hold the "set" button down. Most digital safes will emit a beeping noise when a new combination has been set. Enter your new combination on the safe's interior keypad and hit the "set" button.It may be necessary to hold the button down for ten seconds or so. Push the rod into the safe and hit the "reset" button on the interior keypad. An uncoiled wire hanger is a good option, but you can use whatever you want as long as it gets the job done. Once you have located your safe's interior keypad, find a rod that is long and thin enough to fit through the corresponding bolt opening.Move from bolt opening to bolt opening until you find one that allows you to clearly see the safe's interior keypad. ![]()
0 Comments
Leave a Reply. |